Hello everybody,
I'm writing because i'm a little confused.
I tried to install SAVFL on my REHEL 6.4 64bit , kernel 2.6.32-358.el6.x86_64: i have seen on this page that my kernel is not supported so I was prepared to compile the Autoprotect kernel Module (by this guide).
I have successfully installed rpm files in this way:
rpm -ivh sav-1.0.14-13.i386.rpm savap-x64-1.0.14-13.x86_64.rpm savjlu-1.0.14-13.i386.rpm
after that, i was starting to build the autoprotect, but i said "just in case: let me try if AP is running"
Surprise: IT WAS!
so to be sure i have tried all these command:
/opt/Symantec/symantec_antivirus/ sav info -a
enabled
/etc/init.d/autoprotect restart
Stopping AP: symap: module in use (symap count=24)
Starting AP: symev already loaded.
symap already loaded.
Setting major=248 from /proc/symap/etc/init.d/rtvscand restart
Stopping rtvscand: ... OK
Starting rtvscand: ... OK
/opt/Symantec/symantec_antivirus/ sav info -a
enabled
The question is: Am i really lucky and fortunately everything works properly or is it just a fake-positive output?
Is auto protect really running properly? how to check it?
If it's not: i have to install savap-x64-1.0.14-13.x86_64.rpm or savap-x64-legacy-1.0.14-13.x86_64.rpm?
Hope you can help me.
Thanks a lot,
Skas.