i have tried to upgrade version of hardware diag but don't have cli cmd following from guide please recommend
on my appliance don't have CLI same below when i access to conf t don't have diag upgrade path cmd
Blue Coat ASG-S400>enable
Enable Password:
Blue Coat ASG-S400#conf t
Enter configuration commands, one per line. End with CTRL-Z.
Blue Coat ASG-S400#(config)diag-upgrade-path https://internalwebserver/s400-3_1_2_1-diag.bcsi
ok
Blue Coat ASG-S400#(config)exit
Blue Coat ASG-S400#load diag-upgrade
Downloading from "https://internalwebserver/s400-3_1_2_1-diag.bcsi"
.
Installing...100%
The new diagnostic software has been successfully downloaded.
From enable mode use "restart upgrade" to install the new diagnostic software.
Blue Coat ASG-S400#restart upgrade
