Hi
We are experiencing problems when we create additional radius groups under the LAN Enforcer group.
After we create the second radius group, we assign it to a switch.
When we save the configuration, on the summary screen of the Lan enforcer groups we can see the 2 different IP address of the 2 radius groups (containing 1 radius server each one).
When we open again the lan enforcer group configuration, we see only the first radius group defined. As you can see, in the summary there are two radius server defined.
In the server group properties you can see only the first group created (10.40.1.163).… there was the second one called Radius_Proxy_Group_Collaudo, with the server 10.40.1.164, that disappeared! Please see the picture below:
All the switches that were using this radius group were reverted to the only one defined.
Partner experienced this issue also in other environments.
Other info on the environment:
- 2 sites with two SEPM and replication enabled (the issue persists also if we use 1 site without replication!)
- SEPM 12.1.3
- NAC Appliances 12.1.2
Many Thanks,
Regards,
_______________________________________________
Fabio Giorgio
Technical Account Manager, Symantec Corporation
_______________________________________________